Werbung
EN
Important remark for all electrical connections!
Warning !
When fitting (+) battery cables, (-) earth cables and all
other electrical cables, ensure that these cannot be cut,
damaged, squeezed, heated or melted by any of the
fixed or moving parts of the vehicle or HTL.
Ensure that the wiring of the HTL doesn't interfere with,
or isn't connected or attached to the suspension, the
brake circuits, oil pipes and wiring circuits of the vehicle.
Observe sufficient distance between the electrical ca-
bles of the HTL and the exhaust pipe or other vehicle
parts radiating heat.
Consult the FITTING AND BODY BUILDING INSTRUC-
TIONS of the vehicle manufacturer and follow their rules
for the electrical installation and hygiene of the vehicle
concerned.
DHOLLANDIA disclaims liability for any personal injury
or property damage that results fitting errors, neglect to
follow the fitting instructions, and the instructions of the
vehicle manufacturer.
Pull a flexible protective tube over the full length of all ca-
bles of the (+) battery and (-) earth circuits. Make sure this
conduit is suitable for automotive purposes. Class 1 tubing
(without marking) is suitable for general use, and sustains
a temperature of 85°C continuously, and 100°C peak.
For cables lying in the vicinity of the exhaust pipe, the
catalyser and pre-catalyser, the particle filter,... and other
vehicle components radiating heat, it is compulsory to use
class 2 tubing (marked white) over the full length. This
sustains a temperature of 100°C continuously, and 125°C
peak.
DHOLLANDIA
X
9
Werbung
