KELCH KENOVA set line V224 Bedienungsanleitung Seite 30

1.4 Intended Use
The KENOVA set Line V224 is used for measuring tools. The term tool is used to refer
to the complete tool, that is, the tool (1) in its tool holder (2).
The temperature of the tool must be approximately the same as the ambient
temperature. Tools in previously heated shrink fit chucks must cool down before they
can be measured.
Any other additional use does not constitute the intended use of this device.
Kelch GmbH shall not be liable for any damage resulting from this and the operator
bears the risk of this alone.
The intended use also includes the observation of the Operating Instructions as well as
compliance with the inspection and maintenance intervals prescribed by Kelch GmbH.
1.5 Disposal of the Device
During device construction, special attention was taken to ensure that – where possible
– no compounds were used. This construction concept allows for a high degree of
recycling at the end of the device's service life. We can therefore offer to take back the
device and to dispose of it properly. Furthermore, we would like to point out that you
must comply with the obligations of the "Elektronikschrott-Verordnung" (German
ordinance on electronic refuse) during disposal.
Seite 6
Kelch GmbH • Werkstraße 30 • D-71384 Weinstadt-Endersbach • Tel. (+49)7151 20522 0 • Fax (+49)7151 20522 11 • info@kelchgmbh.de
1 Product Liability and Warranty
Tool
1
Tool holder
2
KENOVA set Line V224
3
Figure 1: KENOVA set Line V224
KENOVA set Line V224  Kelch GmbH 2013