Televes Campnova Boss Kurzanleitung Seite 8

CAMPNOVA BOSS Antenna
Antenna designed especially for caravans, inte-
grated with the BOSS-Tech (system signal with
balanced output).
This system makes the antenna automatically opti-
mize the level of TV signal reception.
It also has a good level of output for optimum re-
ception, while ensuring low power consumption.
Characterised by its easy installation, robustness
and high electrical performance.
Manufactured using materials with high resist-
ance to water, wind, etc.
Accessories included
(fig. 1):
1 Indoor domestic amplifier
1 "Power injector" for battery connection.
1 Cable reel T-100 (14 meters)
3 F type connectors.
3 Screws M 5x16
Allen key size 3mm
*
European patent
General features
10 element Yagui-type antenna (directional), us-
ing Microstrip* technology in UHF, and printed
FM-BIII dipole.
It incorporates our BOSS-Tech shielded amplifier
to manage both VHF and UHF bands; this tech-
nology also allows to pass through these signals
even though the powering is switched-off.
System comprising an FM-BIII-UHF antenna,
power injector for voltages between 12...24V
(use with accumulators), and an indoor domestic
amplifier 1 in / 2 out «Easy F» (196-264V~ => 12V-
150mA), that provides the necessary voltage for
the antenna.
The Indoor domestic amplifier:
- Provides the necessary voltage for the antenna
and additional amplification in FM-BIII and UHF.
- Allows the user to control the operating mode
of the antenna, activating or de-activating its
amplifier.
- Includes a cable for connection to the power
supply.
Installation
If possible, choose an installation point free from
obstacles, where the antenna can be pointed in the
direction of the transmitter (fig.2).
Insert the cable through the inside of the mast (Fig.
7a).
Place the F type connector by screwing it over the
cable (Fig. 6).
Insert entire antenna assembly in the tube (make
sure that the connector and the cable are protect-
ed inside the tube).
Place the antenna in the desired orientation and
proceed to lock it definitely tightening the three
screws on the base with an Allen key size. 3. (Fig.
7b).
8