Honeywell TP-FIT-D-WK Benutzerhandbuch Seite 13

USE & OPERATION (CONTINUED)
FUNCTION BUTTONS (CONTINUED)
Comfort Mode
Dehumidifier automatically adjusts dehumidification Relative Humidity (RH) percentage settings
based on ambient room temperature, for hassle-free operation.
When ambient room temperature is 18°C / 64°F or lower, the dehumidifier adjusts to 55% RH.
When ambient room temperature is between 18°C / 64°F and 25°C / 77°F, the dehumidifier adjusts
to 50% RH.
When ambient room temperature is 25°C / 77°F, or above, the dehumidifier adjusts to 45% RH.
Continuous Mode
The dehumidifier runs continuously with a target of 30%RH or below, on low speed setting. This
mode is used for rooms with more severe dampness and needs continuous dehumidification.
Desired humidity level cannot be adjusted in this mode and will need to be manually switched OFF,
unless unit stops due to a full water tank.
Display Sleep Mode
The top display dims after 1 minute of button inactivity, and then turns off after 3 minutes of inactivity.
Display lights up again when any button is pressed. Mode indicator lights remain ON in display sleep
mode to indicate current settings.
WATER TANK FULL ALERT
When the Water Tank is full, the indicator will be illuminated. The unit will beep for 3 seconds.
The compressor and fan will shut off at the same time. To switch off the indicator light, empty the
water tank and when replacing it ensure the tank is secured properly in place.
IMPORTANT: Do not place the Water Tank on the floor when full. In case of an uneven base which
may cause the tank to spillover.
EN 12