Technical Data; Before Starting The Equipment - EINHELL TC-AG 850 Originalbetriebsanleitung

All manuals and user guides at all-guides.com

4. Technical data

Mains voltage: ........................ 220-240 V ~ 50 Hz
Power input: .............................................. 850 W
Idling speed: ....................................... 11000 rpm
Max. wheel diameter: ............................. 125 mm
Grinding wheel: ......................... 125 x 22 x 6 mm
Cutting wheel: ........................... 125 x 22 x 3 mm
Mounting spindle thread: .............................. M14
Protection class: ...........................................II /
Weight: .......................................................1.7 kg
Danger!
Sound and vibration
Sound and vibration values were measured in
accordance with EN 60745.
L sound pressure level ........................ 90 dB(A)
pA
K uncertainty ............................................. 3 dB
pA
L sound power level ........................ 101 dB(A)
WA
K uncertainty ............................................. 3 dB
WA
Wear ear-muff s.
The impact of noise can cause damage to hea-
ring.
Total vibration values (vector sum of three direc-
tions) determined in accordance with EN 60745.
Surface sanding/grinding:
Vibration emission value a
K uncertainty = 1.5 m/s
2
Additional information for electric power
tools
The specifi ed vibration value was established in
accordance with a standardized testing method. It
may change according to how the electric equip-
ment is used and may exceed the specifi ed value
in exceptional circumstances.
The specifi ed vibration value can be used to
compare the equipment with other electric power
tools.
The specifi ed vibration value can be used for initi-
al assessment of a harmful eff ect.
Anl_TC_AG_850_SPK7.indb 16 Anl_TC_AG_850_SPK7.indb 16
GB
Keep the noise emissions and vibrations to a
minimum.
•
•
•
•
•
•
•
Caution!
Residual risks
Even if you use this electric power tool in
accordance with instructions, certain resi-
dual risks cannot be rules out. The following
hazards may arise in connection with the
equipment's construction and layout:
1. Lung damage if no suitable protective dust
2. Damage to hearing if no suitable ear protec-
3. Health damage caused by hand-arm vib-

5. Before starting the equipment

Before you connect the equipment to the mains
= 13.1 m/s
2
supply make sure that the data on the rating plate
hAG
are identical to the mains data.
Warning!
Always pull the power plug before making
adjustments to the equipment.
5.1 Fitting the additional handle (Fig. 2)
•
•
Left (position A / as
shown)
Right (position B)
- 16 -
Only use appliances which are in perfect wor-
king order.
Service and clean the appliance regularly.
Adapt your working style to suit the appliance.
Do not overload the appliance.
Have the appliance serviced whenever ne-
cessary.
Switch the appliance off when it is not in use.
Wear protective gloves.
mask is used.
tion is used.
rations if the equipment is used over a pro-
longed period or is not properly guided and
maintained.
The angle grinder must not be used without
the additional handle (3).
The additional handle can be secured in any
of 2 positions (A, B).
Tool side Suitable for
Right-handed users
Left-handed users
25.08.2016 08:54:23 25.08.2016 08:54:23