Werbung
Verfügbare Sprachen
Verfügbare Sprachen
DMX-controlled operation
You can control the devices individually via your DMX-controller. Every DMX-channel has a different
occupation with different features. The individual channels and their features are listed under DMX-protocol.
In order order to control the device via DMX, DIP-switch no. 10 must be set to ON, the starting address is
selected via DIP-switches 1-9.
Addressing
Each device occupies 6 channels. To ensure that the control signals are properly directed to each device,
the device requires addressing. This is to be adjusted for every single device by changing the DIP-switches
as set out in the table below.
The starting address is defined as the first channel from which the device will respond to the controller.
Please make sure that you do not have any overlapping channels in order to control each device correctly
and independently from any other fixture on the DMX data link. If two, three or more devices are addressed
similarly, they will work similarly.
21/24
00054364.DOC, Version 1.1
Werbung
