Werbung
Verfügbare Sprachen
Verfügbare Sprachen
ENGLISH
-
Attach the soap bottle to the trigger gun. Fig. 7
-
Apply soap in such a way to cover the whole surface to be cleaned. Apply it from bottom to
top to prevent soap from dripping down and staining the surface.
-
Leave the soap to act on the surface for several minutes. However, in particularly soiled
areas, use a brush to gently scrub. Do not allow soap to dry on the surface.
-
Remove the soap bottle from the trigger gun and replace it with the lance and spray nozzle
or accessory to be used.
-
Rinse the soap from the surface.
Note:
rinse the soap bottle with clean water after every use.
Final rinse
Start the final rinse from bottom to top. Make sure that the surface is well rinsed, and that all
dirt has been removed.
Turning off
-
Make sure there is no detergent in the system.
-
Turn off the motor. Turn off the water supply.
-
Once the product and the water supply have been turned off, press the trigger to
depressurise the device.
-
After each use, wipe the surface of the pressure washer with a clean, damp cloth.
Warning
-
Do not turn off the water supply until the motor has been switched off, as this could cause
serious damage to the pump and motor.
-
Do not remove the high-pressure hose from the machine while the system is being
pressurised. To depressurise the device, turn off the motor and water supply and press the
trigger 2 or 3 times.
Tips for extending the shelf life of the product
-
Do not use the product without water.
-
Do not use the product with hot water.
-
Before setting the spray nozzle pressure (high to low or low to high), release the trigger.
-
Never use the unit for more than 1 minute without spraying water.
5. CLEANING AND MAINTENANCE
-
Use only cleaning products specific for pressure washers.
-
The machine must be switched off and disconnected from the mains for cleaning or
maintenance.
HYD RO BO O S T 1 40 0 E S S E N T I A L
68
ORIGINAL MANUAL TRANSLATION
Werbung
