Zelmer ZFS0919 Benutzerhandbuch Seite 9

EN
experience and knowledge if they have been given
supervision or instruction concerning use of the appliance
in a safe way and if they understand the hazards involved.
Children shall not play with the appliance.
This device is designed for use at a maximum altitude up
to 2000m above sea level.
IMPORTANT WARNINGS
Any other servicing should be performed by an authorized service representative.
This appliance is not for professional use. You should follow the requested breaks. Failure to follow this
instruction carefully may result in damage to the motor. Refer to the maximum continuous use time
KB/MAX. 5 minutes, where 5 is the maximum usage time..
The breaks should last at least 5 minutes.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
B&B Trends S.L. disclaims all liability for damages that may occur to people, animals or objects, for the
non-observance of these warnings.
BEFORE USE
Unpack the device from the carton, remove all stickers, plastic bags, fillers and blockages transport. Note
- the cutting disc also has a transport lock. Clean the device according to the instructions in the "CLEA-
NING AND MAINTENANCE" chapter.
USE
IMPORTANT: After 5 minutes of continuous use it needs to rest for 10 minutes. After 5 cycles, it
needs to rest for half an hour.
Place the device on a flat and dry surface. The person operating the device should apply pressure
buttons with your right hand and hold the presser with your left hand.
Use the slicing thickness adjustment knob (2) to set the required slicing thickness.
Connect the device to the mains.
Place the food to be cut on the mobile carriage (3) between the blade of the cutting disc (5) and the presser (4).
Slide the switch lock button (1A) towards the switch (1) and at the same time press the switch (1) - the
slicer will start working. Releasing the pressure on the switch (1) will stop the slicer.
Move the slicer carriage (3) forwards and backwards, while pressing the food against the knife with the
presser (4). Always use the presser when cutting small pieces of food.
After finishing work, disconnect the slicer from the power supply and then clean it.
ATTENTION! The cutting disc of the machine is sharp. Handle it carefully.
9