Preparing The Scanner - Neoss NeoScan 2000 Installations- Und Bedienungsanleitung

Audio prompts
Scanning sound
When the Enable scanning sound option is enabled, your computer will play a continuous sound when
you are successfully scanning. If the sound stops, it means the scan has stopped. If you need to
continue, please return to the previous scanning area until the scanner resumes scanning and your
computer plays a continuous sound. When a bite registration relationship is successfully scanned, your
computer will also play a short sound.
Warning sound
When the Enable warning sound option is enabled, if the cumulative scanning time of the current case
exceeds the recommended threshold and your computer may not be able to maintain the peak
scanning performance, your computer will play a short warning sounds.
NOTE: If your computer does not have speakers, these options will not take effect.
Preparing the teeth
• If there is a preparation area, retract the gingiva by gingival restriction cords. And extract the cords
just before scanning the preparation.
• Before starting the scan, dry the teeth thoroughly.
• During the scan, re-dry the teeth moderately.

Preparing the scanner

The Scanner Tip attached to the Handpiece provides sanitary shield for patients. Always disinfect the
body of the scanner and perform sterilization on the Scanner Tip after each use.
CAUTION: Scanner Tips are shipped non-sterile. You must sterilize them before the first use.
CAUTION: Avoid any liquid from leaking into the air outlet near the Scanner Tip mount or the air inlet at
the rear of the Handpiece, otherwise the Handpiece may be damaged.
1 4 NeoScan™ 2000 Installation and operation manual // Getting started