Milwaukee PD2-20 Gebrauchsanleitung Seite 4

Keyless chuck
(according to
standard
equipment)
Changing the
keyless drill
chuck
Inserting the tool
Removing the
tool
ENGLISH
All manuals and user guides at all-guides.com
Always disconnect the plug from the
socket before carrying out any work on the
machine.
1.
Open the chuck and loosen the locking
screw with aid of a screwdriver by turning
it clockwise.
2.
Usually, the chuck can be removed by
hand: steady the drill spindle with a fork
wrench and unscrew the chuck by turning
it anti–clockwise.
3.
Should the chuck be stuck on the drill
spindle, fit another fork wrench to the
chuck and the drill spindle (see illustration)
or fix an Allen key in the chuck.
If necessary, hit the key shaft lightly with a
plastic hammer.
4.
Mount the chuck in reverse order.
Aways re–fasten the locking screw after
mounting the chuck. Otherwise thchuck
might become loose in anti–clockwise
operation.
Completely insert the tool shaft into the
open chuck.
Hold the grip and firmly tighten the chuck
by turning the sleeve in the "GRIP"
direction.
After the clamping jaws have tightened
around the tool shaft, turn the chuck a
further 1/4 in order to let the chucking
power retention engage. Only than can the
tool itself be chucked by vigorously turning the sleeve in the "GRIP" direction (it
engages audibly with a grating noise.)
The chucking power retention is mainly needed for percussion drilling.
When the chuck is opened with a strong jerk as far as it will go, it is possible that it
can't be closed anymore. Instead, "grating" can be felt (as if the chuck were
over–tightened). In this case turn the sleeve once more in the "RELEASE"
direction; now it can be closed again. The chuck is not damaged by this "grating".
When percussion drilling in stone the drill bit should be checked for tight seat in the
chuck after first use. If necessary, re–tighten the chuck by hand.
Hold the grip and open the chuck by
turning the sleeve in the "RELEASE"
direction.
When turning the sleeve the chucking
power retention is released, after 1/4 turn
the clamping jaws open and release the
clamped tool.
3
PD2-20, PD2E 20 R