Adjusting The Handle; Trouble Shooting - WOLFF 038588 Original Bedienungsanleitung

2
1
EXTRO-STRIPPER 2, 230 V #038588, 115 V
5.2.1Locking the Pull Back system
(Pic. 3)
For certain floors, it may be required to lock the Pull Back sys-
tem. Use the two screws in the lifting brackets. (Pic. 2)
Unscrew the screws, press the handle to the front and tighten
the screws through the lifting brackets to the angled clips.
If you pull the handle, the blade is lifted from the floor immediately
without stopping the drive.

5.3 Adjusting the handle

The height of the handle can be adjusted to adapt the machine
Screw
to the stature of the operator. To adjust the inclination, loosen the
thumb screw at the foot of the handle.
After changing the hieght of the handle, it may be necessary to
readjust the handle attachment of the clutch.
6.0 Information about certain floor coverings
Needlepunch felt and tufted carpets on jute hessian backings
Cut into strips of approx. 35 cm (14 inch) width. If the flooring is
bonded very tight, cut strips smaller. The machine should remove
the flooring without slipping wheels.
Carpets with foam backing
A sharp blade is essential in order to ensure the floor covering is
removed together with the foam backing.
Remove floorings across the width, particularly if you have an
uneven sub-floor.
Tiles
Use blade of the same width as the tiles and use a new blade.
Tiles above size 30 x 30cm (12 x 12inch) have to be cut into half.
If the sub-floor is uneven, use smaller blades.
In all cases, check from time to time to ensure the blade is still sharp.
If it is not or any distortion has occurred, replace it immediately.

7.0 Trouble Shooting

Trouble
Machine does not
run
Undue force necessary
or excessive vibration
Excessive vibration
#039121,RÄSM
Eventual cause
Power supply
disconnected
blown fuse
defective cable or plug
Blade is blunt
Expendable parts are
worn out
Elimination
Have machine
repaired by a qualified
electrician, respective
change parts
Change blade
Return machine for
service and/or repair
14