Herunterladen Diese Seite drucken

VARON NT-2 Bedienungsanleitung Seite 7

Vorschau ausblenden Andere Handbücher für NT-2:

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 19
Installation and Use
▶Level: Oxygen flow rate setting. 5 gears in total and the flow is highest at 5
gear.
Gear
1
Single pulse oxygen
15
flow rate (ml)
The allowed error is ± 20%.
▶ Battery indicators: Shows the current battery capacity, which is calculated
based on the real-time voltage value and may deviate from the actual situation.
For reference only.
There are 4 battery indicators on the operation panel:
4 lights on -------- battery capacity≧90%
3 lights on -------- 90%>battery capacity≧75%
2 lights on -------- 75%>battery capacity≧50%
1 light on -------- 50%>battery capacity≧25%
1 light flashing -------- battery capacity<25%
▶Alarm light & breath signal light
Alarm light: Red or yellow light will be on and there will be alarm codes shown on
the screen when the device is operating abnormally.
F0001 ---- Low Battery Warning (yellow light on)
F0002 ---- No Breath Detected (yellow light on)
F0006 ---- Oxygen Concentration Below 82% (yellow light on)
07 English
5
2
3
4
20
30
40
50
F0007 ---- Oxygen Concentration Below 50% (yellow light on with an alarm)
th
F0011 ---- High Temperature (red light on with an alarm)
F0012 ---- Oxygen Sensor Abnormality (with an alarm)
Breath signal light: This light flashes when the user's breathing is detected during
the operation of the device, and the device automatically starts the pulse oxygen
supply.
4. Use Guidance
4.1 Connect the power supply
Select the appropriate power connection method according to the use
environment.
▶ Use with built-in battery only
The device has a built-in battery installed by default. It can be turned on if there is
sufficient battery capacity.
▶ Use with an on-board power cord in the car
Connect the input end of the car power cable to the car cigarette lighter, and the
output end to the charging port of the oxygen concentrator. If the red light on the
car power cord lights up, it means that the power supply is connected properly.
Required input: DC12~16.8V/5A.
Installation and Use
Figure 5 - Use of on-board power cable
English
08

Werbung

loading

Verwandte Produkte für VARON NT-2