materials that are no longer required to "Green Dot" recycling collection
points for disposal.
► If possible, keep the original packaging for the device for the duration
of the guarantee period of the device, in order that the device can be
re-packaged properly in the event of a guarantee claim.
9.9 Setup
9.9.1
Setup location requirements:
In order to ensure the safe and trouble-free operation of the device, the
setup location must fulfil the following prerequisites:
•
The device must be set up on a firm, flat, horizontal and heat-resistant
surface with sufficient load-bearing capacity for the oven and the
maximum weight of the expected food that is to be prepared in the
oven.
•
Choose the setup location in such a way that children cannot reach any
hot surfaces on the device.
•
The device is not intended to be installed in a wall or a built-in
cupboard.
•
Do not set up the device in a hot, wet or extremely damp environment
or near flammable material.
•
The device requires an adequate flow of air in order to operate
correctly. Leave a clearance of 20 cm above the oven, 10 cm around
the back and 5 cm on both sides.
•
Do not cover up any openings on the device and do not block these off.
•
Do not remove the device's adjustable feet.
•
The electrical socket must be easily accessible so that the power lead
can be disconnected easily, in the case of an emergency.
•
The installation and assembly of this device in non-stationary setup
locations (e.g. on ships) must be carried out by specialist companies /
electricians, provided they guarantee the prerequisites for the safe use
of this device.
caso MCG 25 Chef (pure white, black)
Please note
57