Godox XPro II N Benutzerhandbuch Seite 8

Battery Level Indication
3 grids
2 grids
1 grid
Blank grid
Blinking
The battery indication only refers to AA alkaline batteries. As the voltage of Ni-MH battery
tends to be low, please do not refer to this chart.
As a Wireless Camera Flash Trigger
Take V1 series camera flash as an example:
1. Turn off the camera and mount the transmitter on camera hotshoe. Then, power on the
flash trigger and the camera
2. Short press the < MENU > Button to enter the C.Fn. menu to set channel and group. Short
press the < MODE.LOCK > Button to set mode, turn the Select Dial to set the level
parameters.
3. Turn on the camera flash V1, press the wireless setting button and < (
<RX> icon will be displayed on the LCD panel. Short press the < MENU > Button to
enter the C.Fn. menu, press the <CH> button to set the same channel to the flash trigger,
and press the <Gr> button ta set the same group to the flash trigger.
Note: please refer to the relevant instruction manual when setting the camera flashes of other
models
4. Press the camera shutter to trigger and the status lamp of the flash trigger turns
red synchronously.
Power Status
Full
Middle
Low
Low power, please replace it.
2.5V The battery level is going to be used
out immediately (please replace new
batteries, as low power leads to no flash or
flash missing in case of long distance).
8
)> and