Werbung
Verfügbare Sprachen
Verfügbare Sprachen
heating up rolls.
Note: Bread must not be toasted on the roll nozzle, since it hinders proper ventilation. Fire
hazard!
2.
Should the toasting process be stopped before the set time is up, press the
button. If you accidently select a wrong setting (e.g.
(R
) instead of
EHEAT
the proper setting.
Caution! Bread, rolls, and parts of the device are very hot during and immediately after use!
7. TIPS REGARDING TAKING BREAD SLICES OUT
1.
When you take the slices out, it would be best if you did not touch them with bare hands.
Danger of burns!
2.
To take out small slices, the lever can be pulled upward approx. 10 additional mm. The slices
will be pulled upward and can be taken out more easily.
3.
Should slices get stuck in the toaster, immediately press the
the device. Then disconnect the power plug from the power supply and allow the device to
cool down completely. Try to take the bread out so as not to damage the toaster. Under no
circumstances should you use current-conducting utensils (like a knife or fork) to take the
bread out.
CLEANING AND MAINTENANCE
1.
Follow Safety Advice.
2.
Attention! Before cleaning, switch the device off and disconnect the power plug from the
socket. Allow the device to cool down completely.
3.
After each use, pull out the crumb tray (10) with the collected crumbs and clean it with a damp
cloth. After cleaning, reinsert the tray. Do not let the crumbs accumulate in the device. Fire
hazard!
4.
Put the device upside down and shake it slightly to remove bread crumbs from the inside of
the toaster.
5.
Use a slightly damp cloth and, if necessary, a little bit of mild cleaning agent to clean the
casing (9). Then dry the device thoroughly.
6.
Attention! Do not use alcohol, acetone, benzene, scouring cleaning agents, etc., to clean the
synthetic parts of the device. Do not use hard brushes or metallic objects.
7.
For storing the toaster, wrap the power cord around the power cord holder on the bottom side
of the device. Store the toaster in a dry, cool place, protected from humidity.
(D
)), first press the
EFROST
9
(D
) instead of
EFROST
(C
) button. Then you can select
ANCEL
(C
) button to switch off
ANCEL
(C
)
ANCEL
(R
), or
EHEAT
Werbung
