Werbung
Keep your body out of the area into which the tool is thrown by
a kickback. The tool is thrown into the direction reverse to the
direction of the disc at the locking point.
Use extreme care when working around edges or sharp
corners. Make sure the attachment cannot become locked into
or bounce back from the work piece. Rotating discs tend to
lock into or bounce back from edges and corners. This may
cause kickback or loss of control.
Additional Safety Notes for Grinding and Cutting
Always use the safety hood intended for the kind of attachment
you are using. The safety hood must be securely attached and
be adjusted in such a way that the highest possible degree of
safety is achieved, e.g. the smallest possible part of the spin-
ning attachment pointing to the operator is free. The safety
hood is intended to protect the operator from flying debris,
fragments of a fractured disc and accidental contact with the
attachment.
The grinding surface of the centre depressed wheels must be
mounted below the plane of the safety hood edge. An improp-
erly mounted wheel that projects through the plane of the
safety hood edge cannot be adequately protected.
Do not attach a saw chain woodcarving blade or toothed saw
blade. Such blades create frequent kickback and loss of con-
trol.
Implement additional safety measures to protect the operator
from the effects of vibration, such as servicing the power tool
and application tools, keeping their hands warm, and organis-
ing workflows correctly.
Use only discs intended for your electric tool and the safety
hood intended for these discs. Discs not intended for the elec-
tric tool cannot be covered in a suitable way and are unsafe.
Use discs only for the purpose they are intended for by the
manufacturer. Never use the side of a cutting disc for grinding.
Safety Notes
24
Werbung
