Iget WP12 Pro Benutzerhandbuch Seite 33

EN
1. Carefully pull out the SIM or microSD card slot
from the side of the phone using the SIM card eject
clip. Then carefully pull it out of the buckle.
Insert the cards into the slots until they click into its
place, and put the slot back into the phone.
2. It is possible to use 2x NANO SIM and 1x
microSD card.
Charging the battery:
Before putting your phone into service you must
recharge its battery for 100%.
1. Connect the adapter to the charger. Please do
not use violence, when plugging the connector.
Keep plugging the micro-USB connector from the
correct side.
2. Connect the charger to the wall outlet.
3. If the battery is fully charged, disconnect the
phone from the charger.
Switching the phone on / off / sleep mode
Make sure that the phone has a SIM card and the
battery is fully charged.
Press and hold the ON/OFF button to switch on the
phone.
Switch off the phone by pressing and holding
ON/OFF button and select Power off, later OK.
Press shortly ON/OFF button to switch the phone
over to the sleep mode.
33