AVer MD330U Bedienungsanleitung Seite 19

Remote Control
The remote control requires two "AAA" batteries. Make sure batteries are installed properly before use.
1
HOME REC SNAP
2
3
4
5
MIC PRIVACY SPEAKER
6
X
7
Model: LY033
Name
8
1. Power
9
2. Home
10
3. Number
11
Buttons
12
13
4. Preset
14
15
16
5. Zoom +/-
17
6. MIC
7. Camera
Select
8. Remote
Control
LED
9. Menu
10. Snap
11. Rec
12. Reset
13. Direction
Buttons
14. Volume +/-
15. Enter
16. Speaker
17. Privacy
Function
Short press to turn on/off the Standby mode.
Move the camera to the Home position.
 Press buttons 0~9 to move the camera to the
pre-configure preset positions.
 Use the buttons to set up preset positions 0~9.
Use the Preset, Number and Direction Buttons to
set up preset positions.
a. Use the Direction Buttons to navigate a
position. Optionally use the "Zoom +" or "Zoom
-" buttons to zoom in/out the image.
b. Press Preset and then press the Number
Buttons (0~9) to save this preset position.
Press to zoom in or zoom out the images.
Press to mute the microphone. Press again to
unmute.
CAM1 to CAM4 buttons. Select a camera to
operate. To set up camera ID, refer to Camera
Selector in the <OSD Menu Tree> chapter.
When pressing the buttons on the remote control,
the LED will light red.
Press to enter or exit the OSD menu.
Press to take a snapshot image. The images will
be stored in the microSD card.
Press to start recording to the micro SD card.
Press the button again to stop recording.
Use the Reset and Number Buttons to cancel a
pre-configured preset position. Press Preset and
then press the Number Buttons (0~9).
Use the Direction Buttons to navigate the live view.
Press to adjust the volume up or down.
Access the OSD menu, confirm the selection or
make a selection in OSD menu.
Press to mute the speaker. Press again to unmute.
Press to enter the Privacy mode. The camera will
move to the Privacy position and microphone will
be off.
9