Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4. CHOOSING THE LAMP
Should the fixture you have purchased have been delivered without lamp, please refer to the
"Compatible Lamps" section on the LDR product's specification sheet or choose from one of the
below‐listed lamps:
1000W G22
LDR recommends Philips lamps
5. LAMP‐HOLDER SETTING
No lamp‐holder setting is available on this model.
6. INSTALLATION OR REPLACEMENT OF THE LAMP
• make sure the unit is cold and disconnected from the mains
• if replacing a lamp use a proper thermal protection for your hands (ex. gloves) in case the lamp
is still hot
• protect the lamp from abrasion and scratches. Do not install or use cracked or broken lamps.
In case a lamp cracks or breaks, disconnect from power supply, allow the unit to cool and
remove/replace the broken lamp
• never touch the lamp bulb with bare hands. Oil and grease can contaminate the quartz surface
and reduce the lamp performance and life
• do not remove the plastic protection around the lamp until after having installed the lamp
• open the lamp‐tray by turning (anti‐clockwise) the ¼ turn fastener. The lamp‐tray will hinge
open
• insert the lamp in the lamp holder. MAKE SURE THE LAMP IS CORRECTLY POSITIONED AND
PERFECTLY VERTICAL.
• carefully close the lamp tray by turning (clockwise) the ¼ turn fastener
7. INSTALLATION
This product is fitted with a pole‐operated suspension stirrup which allows a tilt movement of ±90°
from horizontal and a pan movement of 360°. The stirrup is fitted with DIN 16mm spigot for the
suspension of the product.
Before installing this product make sure the structure you are fixing the product to can withstand
its load and the total load of any other unit installed.
1. Hang the unit to the structure and firmly tighten the clamp.
2. Make sure there is enough distance between each unit to allow free movement
3. Make sure there are no obstructions to the free movement of the yoke
4. Fix the safety bond
8. CONNECT TO THE POWER SUPPLY
• Make sure the plug you are fitting withstands the lamp power load.
• This fixture must be grounded
Tel. +39 0376 771 777 – fax +39 0376 772 140 – email info@ldr.it – web www.ldr.it
LDR Nota f1200 PO 120V User's Manual – 1.0
120V EGT 3200K
Luci della Ribalta srl, Via Berna 14, 46042 Castel Goffredo (MN) Italy
300 hours
4
Werbung
