Werbung
11
11.1
11.2
X
11.3
11.4
EN
11.1
11.2
11.3
Connect the finisher cable to the printer.
Attach the finisher accessory to the printer.
Connect the power cable between the printer
11.4
and a grounded AC outlet.
Turn on the printer, and then wait for it to initialize. On the control panel, set the language, the date/time format,
and the time zone.
NOTE:
For advanced setup for network-connected printers, enter the printer IP address in the address bar of a web browser
after the printer is in a ready state. To find the IP address, select the Information
button, and then select the Ethernet
icon.
CAUTION:
Make sure your power source is adequate for the printer voltage rating. The voltage rating is on the printer label. The printer uses
100-127 Vac or 220-240 Vac and 50/60 Hz. To prevent damage to the printer, use only the power cable that is provided with the printer.
23
Werbung
