Philips Sonicare Cordless Power Flosser 3000 Serie Bedienungsanleitung Seite 15

Cleaning Orthodontic Brackets with the Quad Stream Nozzle
After each use
Charging
Battery Status
Note: If you choose to refill the reservoir during use,
turn the device off while refilling the reservoir and
then pick up where you left off until all spaces around
and between your teeth have been cleaned for a total
of at least one minute.
1 To clean around orthodontic brackets, place the
nozzle tip over each bracket.
2 Gently rotate the nozzle tip around the bracket in a
small circle before moving to the bracket on the next
tooth.
1 Turn off the Cordless Power Flosser.
2 Detach and Empty the reservoir
3 Remove the nozzle from the handle by pushing the
nozzle release button on the top of the handle
4 Rinse the nozzle under the tap
5 Dry any excess water from the nozzle, the outside of
the handle, and the reservoir
6 Insert the nozzle back into the handle or utilize the in-
reservoir nozzle storage feature (see 'Storage').
Note: To facilitate drying, keep the reservoir side fill port
door open or leave the Cordless Power Flosser
disassembled between uses.
This Cordless Power Flosser is designed to provide at least
25 flossing sessions, each session lasting 1 minute.
15
English