Werbung
Verfügbare Sprachen
Verfügbare Sprachen
• Keep area of discharge clear of people, animals, buildings, glass or anything else that
will obstruct clear discharge, cause injury or damage. Wind can also change discharge
direction, so be aware.
Please read all safety guidelines in this manual prior to operation.
3.3. Chipping
Important notes
This chipper was designed for chipping 12cm(5") diameter and smaller trees and
branches. Never use this machine for any other purpose as it could cause serious
injury.
Processing 12cm (5")or smaller trees & branches
• Your chipper can process dry or green material.
• Feed branch into chipper hopper.
• Keep branch at same angle as chipper hopper.
• As the branch becomes short and is inside the chipper hopper, finish processing it by
pushing it into the chipper with the next branch if needed.
• If branches are 5cm(2") or larger in diameter, feed only one branch at a time into
the chipper.
• If branches are smaller than 5cm, more than one at a time can be fed into the
chipper.
• Green branches process easier than hard wood.
• Make sure protective gloves are worn when feeding the chipper.
Chipping notes
• Use common sense when using your chipper.
• Learn to recognize the change in the sound of your machine when it is overloaded.
• Become familiar with successful operating conditions and avoid those that can
overload and
damage the machine.
• If the machine becomes jammed by overloading or any other cause, stop the
machine
immediately.
• If you jam the machine and do not stop the engine it can:
• Burn the belt
• Ruin the clutch
This damage can be costly and it is not covered under warranty. For this reason, it is
important that you immediately shut off the machine if it becomes jammed.
Werbung
