Werbung
after somewhat prolonged use depending on the type of cooking and how regularly the grease filter is cleaned.
•
Washable activated carbon filter (for filter version only):
The carbon filter can be washed every two months (or when indicated by the filter saturation system - if included in your
model). As indicated in the drawing section: remove the grease filter, remove the carbon filter and wash using hot water
and suitable detergents or in a dishwasher at 65°C (if washing in a dishwasher, carry out the complete washing cycle
without dishes inside). Remove any excess water without damaging the filter, then place it in the oven for 10 minutes at
100°C to dry it out completely. Put the anti-grease filters back in place.
Replace the foam layer every 3 years and each time the cloth appears damaged.
Illumination
• Lighting system : The lighting system cannot be replaced by the user, contact Customer Service in case of malfunc-
tion.
• The lighting system is based on LED technology. LEDs provide optimal illumination, last up to 10 times longer than
conventional lamps and save 90% of electricity.
OPERATION
L3
L5
L1
L2
L4
T1
T2
T3
T4
T5
T1 Motor ON/OFF
Press the button to start the hood at speed 1.
Press the button during operation to switch the hood OFF.
T2 Increase speed
Press the button to switch the hood from OFF to speed 1.
Press the button (with hood ON) to increase the motor speed from speed 1 to intensive.
With each speed, the respective LED lights up.
Speed 1 LED L1
Speed 2 LED L2
Speed 3 LED L3
Intensive speed LED L4 (flashing)
Intensive speed is timed. Standard timing is 5', after which the hood switches to speed 2.
To deactivate the function before the time expires, press T2; the hood will switch to speed 1; press T1 to switch off the
hood.
T3 Lights ON/OFF
T4 Speed timer
T5 Operating status indicator.
Speed timer
The speed timer is enabled by pressing T4; after the set time, the hood switches off.
Timing is subdivided as follows:
Speed 1 - 20 minutes (LED L1 flashing)
Speed 2 - 15 minutes (LED L2 flashing)
Speed 3 - 10 minutes (LED L3 flashing)
Intensive speed - 5 minutes (LED L4 flashing).
During timed operation, press T1 to switch off the hood; press T2 or T4 to make the hood
go back to the set speed.
Grease filter warning
After 40 hours of operation, LED L5 lights up.
When this warning appears, it means that the installed grease filter needs to be washed.
To reset the warning, press and hold key T1 for 3".
9
Werbung
