Werbung
Downloaded by: pm_clarallort on 13-07-2023 15:24 CEST
NB: Do not use the appliance while it is
connected to the charger.
HOW TO CHECK THE BATTERY'S
CHARGE LEVEL WHEN CHARGING
LED light from the charger will become green
when the battery is fully charged.
NB: For a long battery life, it is advisable
to charge the battery, before it runs out
completely.
ASSEMBLING THE BATTERY/S
Insert the battery to the hole at the bottom of
the appliance. Until it's fully mounted.
INSTRUCTIONS FOR USE
BEFORE USE:
Make sure that all the product's packaging has
been removed.
Ensure the battery is correctly mounted to the
appliance and charged.
Prepare the appliance according to the function
you wish to use:
ASSEMBLY OF THE MINIGRINDER
ACCESSORIES
Mounting and dismounting chuck adaptors
(L)
Press the locking button (C) and turn the shaft
until it locks.
With the spanner (K) loosen the nut by turning
it anticlockwise.
Dismount the chuck covering and it will leave
the mounted chuck adapter exposed.
Remove the one mounted and place the one
you need to perform the operation.
To mount it proceed the same procedure
backwards.
Placing and removing the minigrinder
accessories
Press the locking button (C) and turn the shaft
until it locks.
With the spanner (K) loosen the nut by turning
it anticlockwise.
Soften the chuck covering turning it
anticlockwise.
Insert the accessory you need to perform the
operation.
Tighten again the chuck covering.
USE:
Ensure the battery is placed correctly and that
the chuck covering is tighten firmly.
Turn the appliance on, by using the on/off
switch.
ELECTRONIC SPEED CONTROL:
The speed of the appliance can be regulated
by using the speed regulator control (D). This
function is very useful, as it makes it possible
to adapt the speed of the appliance to the type
of work that needs to be done.
ONCE YOU HAVE FINISHED USING THE
APPLIANCE:
Switch the On/Off switch to the off position.
Dismount any minigrinder tool according to this
manual.
Clean the appliance, charge the battery or
store the appliance in the case.
MAINTENANCE AND CARE
WARNING! Always unplug the machine before
carrying out work on it.
Werbung
