Profi-AirBrush AB01117 Bedienungsanleitung Seite 6

6 English
11. RECOGNISING AND REPAIRING OF MISTAKES
Problem
Color drips from the nozzle
Color passes from the color
needle to the needle seal
The spray pattern is
crescent-shaped
The spray pattern is drop /
oval shaped
Uneven, stuttering color
beam
Color bubbles in color cup
12. EU DECLARATION OF CONFORMITY
The undersigned, Amur S.à r.l., 36, Rue de la Gare, L-5540 Remich, certifies that the product named overleaf,
namely Double-Action-Gun 128 D 0,35 / 130 D 0,3 / 134 D 0,3 / 134s / 182 D 0,5 / 180 D 0,2-C / Single-Action-Gun 138 D 0,8 as
placed on the market, complies with the relevant provisions listed below, the relevant EU harmonised directives and
the EU standard for safety. This declaration of conformity applies insofar as no modifications are made to the product.
The sole responsibility for issuing this declaration of conformity lies with the manufacturer.
The sole authorised person to keep the technical documents:
Amur S.à r.l. - 36, Rue de la Gare - L-5540 Remich
Signed for and on behalf of:
Amur S.à r.l.
Remich, 05.06.2023
i.V. Dipl. Phys. Peter Neumüller
Technical Manager
Possible cause
An particle between the nozzle and the
needle prevents a seal
Self-tensioning needle seal damaged
or absent
Air holes or air circulation clogged
Dirt on the nozzle cup or the air outlet
Too little paint in the container
Color nozzle not attached
Self-adjusting needle seal
Nozzles dirty or damaged
Atomizing air flows through the Color
channel to the color cup.
The paint nozzle is not enough attracted
Nozzle is not completely screwed on, air
circuit blocked or the seat and
Nozzle insert is damaged or defective
Solution
Remove color needle and nozzle and
clean or use new nozzle set
Replace needle seal
Dilute in thinner, then clean with nozzle
cleaning needles
Rotate the air nozzle 180 ° if the pattern
does not change, clean the nozzle cup
and the air guide
Top up color
Tighten the parts
If necessary, clean or replace the parts
Tighten the parts
If necessary, clean or replace the parts