Werbung
Verfügbare Sprachen
Verfügbare Sprachen
c) Site of Setup, Connection
• Install or operate the product in a way that it is out of reach of children.
• Using the product in or close to garden ponds, wells, swimming pools, fountains, etc. is only permissible
if the product is operated by a leakage current protection switch (FI-protection switch) with a nominal
error current of <=30 mA).
If persons are present in a pool, swimming pond or garden pond, the product must not be operated in it.
In Austria, the product must only be installed and operated in or close to swimming pools and garden
ponds if a suitable ÖVE-tested safety separating transformer is switched in front of it in addition to the
leakage current protection switch.
• There must not be any ambience temperatures around or below freezing (<0 °C) at the operating site.
The water in the clear water pump would freeze and the higher volume of ice destroys the clear water
pump. Store the product dry and protected from frost in winter.
• If you are using an extension cord or if placement of cables to the clear water pump is required, these
cables must not have a cross section of less than the clear water pump's. Only use extension lines with
protective ground that are suitable for outdoor use.
• Protect the mains line of the clear water pump against cold/heat, oil/gasoline and sharp edges; do not
step on the mains line, do not drive on it (e.g. wheelbarrow, bicycle, car). Do not bend the mains line and
do not place any objects on it.
• Ensure that electrical plug connections are in flooding-safe areas; otherwise, there is a danger to life
from electric shock! If required, use suitable protective housings for the plug connections.
• Protect the mains plug from wetness! Never touch the mains plug with wet hands! There is danger to
life from electric shock!
• The mains cable or mains plug must not be cut off.
d) Operation
• Only clear, clean fresh water with a temperature of no more than 35 °C must be conveyed.
• The conveyed liquid must be clean. The build of the clear water pump permits contamination only up to
a grain size of 5 mm.
• The product is not suitable for conveying potable water.
• The product is not suitable for conveying corrosive/caustic, flammable or explosive liquids (e.g. gasoline,
fuel oil, nitro diluent), grease, oils, salt water or sewage from toilets.
• The mains socket to which the clear water pump is connected must be easily accessible. The mains
cable must point downwards from the mains socket so that the water running back at the cable cannot
enter the mains socket.
• If the clear water pump is to be operated, e.g., in a well, it must be suitably attached, e.g. with a rope.
The rope must be able to hold at least 3 times the weight of the clear water pump for reasons of safety.
Never attach the clear water pump via its mains cable; also never use the mains cable to carry, hold or
submerse the clear water pump!
• The product is not protected against running dry.
• The product must not be operated unsupervised.
• The product must not work in permanent operation.
18
Werbung
