Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Assembly
1. Flush through the supply pipes.
2. Place the mixer including the sealing washer in
position on the basin.
3. Slip the fixation piece including the washer over
the threaded pin and tighten the nut.
4. Connect the supply pipes to the angle valves;
cold right - hot left.
5. Connect the pull rod to the pop-up waste.
Large differences in pressure between the hot and
cold water supply should be balanced.
Operation
The mixer is actuated by lifting the lever head.
Swivel to the left = hot water,
swivel to the right = cold water.
Technical Data
This mixer series-produced with
waterdimmer (flow limiter)
Rate of flow with waterdimmer:
Rate of flow without waterdimmer:
Operating pressure:
Recommended operating pressure:
Test pressure:
Hot water temperature:
Recommended hot water temp.:
Hansgrohe single lever mixers can be used together
with hydraulically and thermically controlled
continuous flow heaters if the flow pressure is at
least 1.5 bars.
If the continuous flow heater makes any problems or
there comes not enough water, the waterdimmer
(flow limiter 5a) located behind the mousseur must
be removed.
To adjust the hot water limiter on single lever mixers,
please see page 12.
No adjustment is necessary when using a
continuous flow water heater.
6
English
Spare parts
1
1.1 screw cover
2
3
4
5
6
7
7 l/min 3 bars
14 l/min 3 bars
max. 10 bars
1 - 5 bars
16 bars
max. 80° C
65° C
lever head
flange
nut
cartridge cpl.
aerator cpl. (10)
pull rod
fixation cpl.
96338000
94192000
94194000
92730000
13085000
92620000
96016000
Werbung
