Werbung
Verfügbare Sprachen
Verfügbare Sprachen
2. Before starting the operation
The
always be used, inspected and
maintained in compliance with
the local government, state or
federal regulations.
• Drain the compressor tank and remove the
condensate from the air lines. Carefully read
through the operating instructions for the
compressor.
IMPORTANT:
We recommend using air filters and
a compressed air line lubricator.
ATTENTION!
Disconnect the compressed air sup-
ply prior to lubricating, connecting or
disconnecting the tool.
• Lubricate the tool; see the section on main
tenance in these operating instructions.
• Remove the dust cap on the compressed air
inlet.
• Connect the tool to a hose of suitable size,
see table on page 15.
3. Commissioning
• Switch on the compressor so that the air
tank can be filled.
• Turn the compressor regulator to approx.
90 PSI or 6.3 bar. The max. working pres-
sure of this tool is approx. 90 PSI or 6.3 bar.
• The power may vary depending on the size
of the air compressor and the volume of the
compressed air output.
• Do not use damaged or worn air hoses or
adapters of inferior quality.
• The technical data provided refers to an
operation of the tool at a pressure of 6.3 bar.
• Caution is required at all times when using
the tool. Negligent operation may cause
damage to the inner parts or the housing and
limit the working performance.
• Press the operating lever to operate the tool.
• Release the operating lever to stop the tool.
• Please note that the tool still carries on
running after the operating lever has been
released.
16
3
Design and function
pneumatic
tools
Immer persönliche Schutzausrüstung tragen!
Always wear personal protective equipment!
^ hazet.com • ] info@hazet.de
• The direction of rotation is set via the set-
ting on the top of the housing; two settings
must
tightening, one setting loosening
• After completing the operation, switch off
the compressor and store it in accordance
with the operating instructions of the com-
pressor.
• Only use clean and dry air at a max. pres-
sure of 90 PSI or 6.3 bar. Dust, flammable
vapour and high humidity can result in
damage to the pneumatic tool's motor.
• Do not remove any stickers and replace
damaged stickers.
• Keep hands, loose clothing and long hair
away from the tool's moving part.
• Maximum efficiency due to the ground-
breaking HAZET Twin Turbo technology
enables high torques with compact design.
• Innovative 8-blade air motor with 25% hig-
her impact performance ensures maximum
torques.
• Long service life and high efficiency in
industrial and automotive applications.
• Compact design optimised for work in
confined spaces
Twin Turbo
2 x Air inlet
4 x Air outlet
Werbung
