Indel B SLIM 70 Bedienungsanleitung Seite 38

VENTILATION
The product's performance depends on the proper ventilation. Ventilation is through
the front vents on the product. The cold air enters through the lower vent on the front
and passes through the upper vent. Here it cools the refrigerant system. The hot air
comes out through the upper vent.
ATTENTION
Do not block the upper and lower vents.
DOOR PANEL INSTALLATION
To match the product to the interior, a door panel may be installed, as indicated below.
The door panel must be mounted before installing the product.
1. Remove the door from the hinges (see section 4.7 a pagina 76);
2. Remove the lower panel stop (A), gently extracting it;
3. Remove the panel by sliding it gently out of its housing;
4. Insert the new panel (B) in the door frame;
5. Reset the lower stop (A) and the angle elements, snapping them in place.
36 SLIM OFF_(DC)_IM_20221115