Technical Data - EINHELL 34.017.80 Originalbetriebsanleitung

Anleitung_BG_BC_25_SPK1:_

4. Technical data

Engine type
2-stroke engine, air-cooled, chrome cylinder
Engine power (max.)
Displacement
Idle speed of engine
Max. engine speed
Max. twin line speed
Scythe
Trimmer
Ignition
Drive
Weight (with empty tank)
Long handle length
Cutting circle diameter of line
Cutting circle diameter of blade
Cutting line length
Cutting line diameter:
Tank capacity
Spark plug
Vibration a
hV
Idling speed (max.)
Idling speed (max.)
K uncertainty
hV
L sound pressure level
pA
K uncertainty
pA
L sound power level
WA
K uncertainty
WA
5. Installation
5.1 Installing the long handle
Install the long handle as shown in Figures D1 – D3.
Do not tighten the screws until you have set the
perfect working position with the carrying strap. The
long handle should be aligned as shown in Figure A.
5.2 Mounting the blade guard hood
Important: The cutting blade guard hood must be
fitted if you wish to work with the cutting blade. The
guard hood for the cutting blade must be installed as
shown in Figures D4 – D5.
25.05.2010 15:59 Uhr Seite 19
5.3 Fitting / Replacing the cutting blade
The fitting of the cutting blade is shown in
Figures E1 - E7. To dismantle, proceed in reverse
order.
Push the distance spacer (A) over the spline
shaft (Fig. E2)
0.75 kW/1.0 hp
Fit the carrier plate (B) onto the spline shaft (Fig.
25 cc
E3)
Securely fit the cutting blade (C) on the cover
3000 rpm
ring (Fig. E4)
10,500 rpm
Slide the fastening ring (D) over the thread (Fig.
E5)
Look for the hole in the carrier plate, line up with
9,500 rpm
the notch beneath it, lock with the supplied
8,000 rpm
locking pin (23), and tighten the nut (E).
Electronic
Important: Left-hand screw thread (Fig. E6)
Slide the split pin (21) through the hole in the
Centrifugal clutch
drive shaft and bend the lugs around the shaft as
6,2 kg
shown in Figure 21.
132 cm
5.4 Fitting the cutting line guard hood
Ø 43 cm
Important: The cutting line guard hood must be
Ø 23 cm
additionally fitted if you want to work with the cutting
4.0 m
line.
Remove the three screws on the blade guard
2.5 mm
hood (Fig. F1)
0.45 l
Place the cutting line guard hood onto the blade
L8RTC guard hood (Fig. F2)
Secure the cutting line guard hold with the two
previously removed screws (Fig. F3)
4.01 m/s
2
9.14 m/s 2 5.5 Fitting / Replacing the line spool
The fitting of the line spool is shown on Figures F4.
1,5 m/s 2
To dismantle, proceed in reverse order.
98.2 dB (A)
3 dB
Look for the hole in the carrier plate, line up with the
notch beneath it, lock with the supplied locking pin
112 dB (A)
(23), and screw the line spool onto the thread.
3 dB
Important: Left-hand screw thread (Fig. E6)
GB
19