Mounting The Handlebar; Adjusting Of The Folding Device - URBANGLIDE RIDE 8 Plus Bedienungsanleitung

Assembly
1.
2.
Disassembly
To disassemble the handlebars of your scooter, follow these steps:
1.
2.
Screw adjustment

Mounting the handlebar

To assemble the handlebars of your scooter, follow these steps:
Insert the two handles into the handle of your scooter.
Screw the two handles
Unscrew the two handles of the handle of your scooter.
Remove both handles.

Adjusting of the folding device

Locking pin
1.When the space in the folding device is too
large, the upper screw can be turned to the
right with an Allen key and the left and right
screws must be adjusted.
2.Before adjustment, make sure that the
scooter is in the adjustment lock state and
after adjustment, that the folding switch is
elastic and can be used normally. The locking
pin may normally fall down.
11