Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Prepare the surfaces and lubricate the bare machine parts with an acid-free lubricating oil (e.g.
WD40 rust inhibitor).
16.2
Maintenance
The machine is low-maintenance and only a few parts need to be serviced. Malfunctions or defects
that could affect your safety must be repaired immediately!
Before each operation, check the perfect condition of the safety devices.
•
•
Regularly check the perfect and legible condition of the warning and safety labels of the
machine.
•
Regularly check the hydraulic unit and the oil level.
Regularly check hydraulic hoses and compressed air hoses.
•
Regularly check the wire rope of the hand winch
•
•
Use only original spare parts recommended by the manufacturer.
Maintenance plan
The type and degree of machine wear depends to a large extent on the operating conditions. The
following intervals apply when the machine is used within the technical limits:
Interval
Before usage
Once a week
If required
Annually
Every 2 years
Change hydraulic oil
16.3
Storage
Store the machine in a dry, frost-proof and lockable place when not in use. Make sure that
unauthorised persons and especially children do not have access to the machine.
Improper storage can damage and destroy important components. Only store packed
or already unpacked parts under the intended ambient conditions!
HOLZMANN Maschinen GmbH
Components
Machine
Frame, working table, bolts
Screw connections
Hydraulic unit, pressure cylinder
Hydraulic unit
Piston
Hydraulic and compressed air hoses,
wire rope
Hydraulic oil
Retract the stamp completely.
•
Open the oil inlet (1) on the hydraulic pump (2).
•
•
Drain hydraulic oil.
Fill recommend hydraulic oil (amount and specification see techn.
•
data) into the oil filler opening (3)
Screw in the oil inlet (pay attention to the sealing (4)!)
•
•
Bleed the hydraulic unit.
www.holzmann-maschinen.at
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
Visual inspection for dirt, clean if necessary
Visual inspection, replace if necessary
Check for tightness, retighten if necessary
Check for leaks, seal if necessary
Refill oil
Clean and lubricate
Check for wear, replace if necessary
Change oil
N O TE
Action
WP50ECO | WP75ECO
30
Werbung
Inhaltsverzeichnis
