Handling - HOLZMANN-MASCHINEN WP75ECO Betriebsanleitung

15.3

Handling

Examples of workpiece positioning:
HOLZMANN Maschinen GmbH
1. Place the working table to the required height position.
Upwards:
• Remove the bed frame pins (2)
• Move the working table to the desired position with the
hand winch (3).
• Insert and secure the removed bed frame pins (2) in
position (1)
• Lower the working table onto them
• Then attach the two bed frame pins (1) to position (2) for
final fixing
Downwards:
• Remove the bed frame pins (1)
• Insert the bed frame pins (1) into the desired position and
secure it.
• Hold the working table in position with the hand winch (3)
and remove the two bed frame pins (2).
• The working table can then be lowered to the desired
position using the hand winch (3)
• Fix and secure the working bed with the bed frame pins (2)
2. Place the workpiece support (1) or other supporting/clamping
device adapted to the workpiece on the working table. Then
place the workpiece on the workpiece support.
NOTE:
Position the workpiece centrally (working table/cylinder)
CAUTION: Only select supporting/clamping devices that are
designed for the permissible pressing force and provide the
workpiece with a secure hold during the complete pressing
process.
3. Moving the stamp towards the workpiece:
With compressed air supply:
• Connect the air inlet fitting to the fitting of the air supply hose
• Close the pressure valve (3).
• Pump the handle (1) or open the air valve (2) until the stamp nears
the workpiece
With compressed air supply:
• Close the pressure valve (3).
• Pump the handle (1) until the stamp nears the workpiece
www.holzmann-maschinen.at
OPERATION
28
WP50ECO | WP75ECO