Inhaltsverzeichnis
Werbung
36
FOUR LFO
(17) RESET/SYNC 2 – a gate or clock applied to this socket causes different actions
according to mode:
• In SYNC mode it will synchronize LFO 2 to the external clock.
• In RESET mode when the LFOs are free-running it will reset the waveform
cycle of LFO 2.
• In RESET mode when the LFOs are in QUAD, PHASE or DIVIDE it will pause
all four LFOs.
(18) RESET/SYNC 3 – a gate or clock applied to this socket causes different actions
according to mode:
• In SYNC mode it will synchronize LFO 3 to the external clock.
• In RESET mode when the LFOs are free-running it will reset the waveform
cycle of LFO 3.
• In RESET mode when the LFOs are in QUAD, PHASE or DIVIDE it will reverse
all four LFOs.
(19) RESET/SYNC 4 – a gate or clock applied to this socket causes different actions
according to mode:
• In SYNC mode it will synchronize LFO 4 to the external clock.
• In RESET mode when the LFOs are free-running it will reset the waveform
cycle of LFO 4.
• In RESET mode when the LFOs are in QUAD, PHASE or DIVIDE it will shift the
assignable waveform to the next option on all four LFOs, regardless of the
setting of switch 8. The waveform selected by switch 8 will be selected
again if the mode is changed.
(20) SINE – sine wave outputs for each LFO.
(21) ASSIGN – assignable waveform outputs for each LFO, according to where
switch 8 is set.
(22) SQUARE – square wave outputs for each LFO.
PRECISION
Pressing and holding button 7 puts the FOUR LFO into precision mode to allow
precise adjustment. The LED for the current mode will flash, and the faders will
make fine adjustments around the centre point. When exiting precision mode the
faders will not necessarily indicate the current setting, so the relevant LED will
continue to flash to show this.
FIRMWARE UPDATE
On the edge of the circuit board next to the mode switch (6) there is a micro USB
socket for updating the FOUR LED's firmware, using the SynthTribe application.
HINTS AND TIPS
• Use the output of one LFO to modulate the selected parameter of another.
Or cascade your modulation . . .
• In free-running mode use a square wave from one LFO to reset another.
37
Quick Start Guide
Werbung
Inhaltsverzeichnis
