ND tackle BAIT BOAT 2 Benutzerhandbuch Seite 14

How to use the mapping function
1. Click on the icon that represents a path
between two points. The mapping menu opens.
3
2
4. When you are done, click on the calculator
symbol. The route is now calculated and the
individual points for the mapping are set.
5
Note: For mapping, a sonar must be operated in parallel that supports the creation of bathymetric
maps.
23
page
1
2. Click on the cube with the lines, a figure
with four end points appears on the map.
3. Move the points and define the figure.
You can also delete the figure with the
bin symbol.
4
5. When the calculation process is finished, click
on the icon with the arrow pointing to the right
to start the mapping.
How to measure the distance
between two points
1. Click on the ruler symbol. It changes colour.
1
2. Now press on a point on the map from which the measurement should start and then
again on an end point.
3. A line is drawn between the points and the distance is displayed.
4. Press the ruler symbol to finish the measurement.
24
page