Beko B40K 590G Kurzanleitung Seite 142

SETTING FURTHER CHANNELS
DISEqC Mode
Based on the number of current satellite sys-
tem, select the option »Off« »DiSEqC 1.0«
< >
with » « or » «.
– »Off«: For satellite systems with single
antenna.
– » DiSEqC 1.0« switch allows for receiving
from maximum four satellites at the same
time.
From »LNB Selection« use »
to make the »1/4«, »2/4«, »3/4« or
»4/4« selection for the satellite that
corresponds to relevant DiSEqC posi-
tions.
8 Exit the antenna settings with »
9 Select the Channel Type.
Press » « or » « to select whether you
V Λ
want to search for only digital channels
(Digital) or only radio channels (Radio) or
both (Digital + Radio) and press »OK« to
select and mark or unmark the »Digital«
and/or »Radio« items.
10 Select Scan Mode.
To select whether you want to search for
only free digital television channels (Free),
only scrambled digital television channels
(Scrambled) or both (Free + Scrambled),
« and press OK« to select
press » « or »
V Λ
and mark or unmark the »Free« and/or
»Scrambled« items.
11 Press » « (red) to start searching.
Notes:
When updating via the same satellites a
7
security query is displayed at the start of a
search.
If the previously stored channels should
7
be retained in the channel list and the new
channels found be added to it, then press
» « (green).
Television / User Manual
If » « (red) is pressed, the saved channels
7
will be deleted from the current channel list.
– The »Digital Searching« menu appears,
and the scan for TV channels begins.
– The search is complete as soon as the
message »Search is completed!« appears.
Note:
The search can be aborted with »EXIT«.
7
< >
12 Switch to the Channel Editor with »
« or »
(yellow);
or
press »EXIT« to end the setting.
« (blue).
Note:
Repeat the procedure from point 1 for the
7
settings of the second satellite or any others.
These channels will be added to the bottom
of the channel table.
-----------------------------------------------------
«
63 / 78 EN