Using External Devices; Digi Link; The Digi Link Functions Of The Television - Beko B40K 590G Kurzanleitung

USING EXTERNAL DEVICES

DIGI LINK

Your television is equipped
with DIGI LINK feature. This
feature utilizes CEC (Consumer
Electronics Control) protocol.
CEC allows you to make an
HDMI connection on sockets HDMI between
your TV and DVD player, STB or video recorder
and control such equipments with the remote
control of the television.
This feature must also be supported by the
device you will connect.
You television supports the following functions.
For detailed information about this function,
read user manual of the external device.
The Digi Link functions of the
television
Turning on external device from
standby mode
When you switch on your external device (e.g.
DVD player) from standby mode, your television
will be turned on from standby mode as well
and it will switch to the HDMI source that the
external device is connected to.
Depending on the features of the external
device (e.g. AV receiver) can start and your
television can stay on stand-by mode.
Selecting the HDMI source from the
television
When you switch on your external device
(e.g. DVD player), your television will switch
to the HDMI source that the external device is
connected to your TV should be open.
Selecting the menu language
When you select menu language on your TV,
menu language of the external device will
change as well (if your DVD player supports).
52 / 78 EN
---------------------------------------------------------------
Switching off the external device from
standby mode
After switching your television to standby, your
external device (e.g. DVD player) will also
switch to standby if it is switched on.
DIGI LINK is always active on your television.
Refer to the user manual of your external device
to learn how to activate this feature on it.
Searching and selecting the active ex-
ternal device
You can connect up to 11 devices that support
DIGILINK to this television.
1 Open the Tools menu with »TOOLS«.
2 Select the line »Digilink« with »
and press »OK« to confirm.
– Connected devices are searched and the
ones that are found are displayed on the
»Device List« menu.
3 Start device search with »
– The devices found are shown in the menu.
4 Select the device that you want to control
with » « or » « and mark it with »OK«.
V Λ
– If the selected device is connected to a
different source than the current one, you
will automatically switch to the source to
which the device is connected.
Television / User Manual
« or » «
V Λ
« (blue).