Instructions For Use - Weka KS30 S Betriebsanleitung

GB
INSTRUCTIONS FOR USE - DIAMOND DRILL RIG KS30
Please read carefully before putting the drill rig into operation!
With the WEKA drill rig, you own an outstanding quality product with which you will be very satisfied,
provided you use it properly.
1. G E N E R A L S A F E T Y P R E C A U T I O N S
WARNING! Read all safety precautions and instructions. Failures in the compliance with these
safety precautions and instructions can cause electric shock, fire and/or heavy injuries.
Please keep these safety precautions and instructions for the future.
1) Security of employment
a) Keep your working area clean and well illuminated. Disorder or unilluminated working
areas can cause accidents.
b) Keep children and other persons away from the electric tool while using it. When
being distracted, you can lose the control on the device.
2) Personal safety
a) Be attentive, pay attention to what you do and go to work with the electric tool with
reason. Do not use an electric tool when you are tired or under the influence of
drugs, alcohol or pharmaceuticals. One moment of carelessness while using an electric
tool kann cause serious injuries.
b) Wear personal protective equipment and always goggles. The wearing of personal
protective equipment, like dust mask, skid-proof shoes, protection helmet or hearing
protection, depending on the kind and use of the electric tool reduces the risk of injuries.
c) Avoid abnormal posture. Care for safe standing and keep the balance anytime. Thus
you can control the electric tool better in unexpected situations.
d) Wear suitable clothing. Do not wear wide clothing or jewelry. Keep hair, clothing
and gloves away from moving parts. Wide clothing, jewelry or long hair can be caught
by moving parts.
e) If there is the possibility to assemble a dust exhauster and collecting device, make
sure that these are connected and used correctly. The use of a dust exhauster can
reduce dangers by dust.
f) If attaching the drill stand at the workpiece by means of dowels or screws, make
sure that the used anchorage is able to hold the machine during operation securely.
If the workpiece is not resistant or porose the dowel can be removed whereby the drill
stand separates from the workpiece.
g) When fastening the drill stand on the workpiece by means of vacuum pump make
sure that the surface is smooth, clean and non-porous. Do not mount the drill to
laminated surfaces such as on tiles and coatings of composites. If the surface of the
workpiece is not smooth, flat or sufficiently secured, the vacuum plate can loosen from the
workpiece.
h) Make sure that the vacuum power is sufficiently safe before drilling. If there is
insufficient vacuum power the vacuum plate can loosen from the workpiece.
i) Never perform overhead drilling when the machine is attached only by vacuum
plate. In case of loss of the vacuum, the vacuum plate detaches from the workpiece.
j) Make sure that persons and working area on the opposite site are protected if you
drill through walls and ceilings. The drill bit can overlap the borehole and the drill core
can fall out of the drill bit on the other side.
k) For overhead drilling always use a water collecting system prescribed by the
manufacturer. Make sure that no water seeps into the tool. The penetration of water
into the power tool increases the risk of electric shock.
7