Meec tools 016372 Bedienungsanleitung Seite 33

3. Connect the air hose with quick-coupling
to the 1/4" quick-coupling (5) on the
product. Check that the quick-coupling on
the hose is fully pressed in and locked in
the quick-coupling (5) on the product.
FIG. 4
NOTE:
When the product is not in use the air hose
can be wound up on the hose retainer.
Follow the instructions below to disconnect the
air hose.
• Check that the output pressure is 0 bar.
Otherwise, release the air until the tank is
pressureless.
• Keep a firm grip on the end of the hose
when it is released from the quick-
coupling (5).
• Pull back the sleeve on the quick-coupling.
• Hold the quick-coupling firmly on the air
hose and pull it out of the quick-coupling
(5) on the product.
STARTING/SWITCHING OFF
• Fit the battery.
• Put the power switch in the ON position
to start the product.
• Put the switch in the OFF position to
switch off the product.
NOTE:
When the switch is in the ON position the
product starts automatically when the
pressure in the air tank drops below the set
limit value, and switches off when the set
closing pressure is reached.
WARNING!
• Never exceed the nominal pressure for
the product, as specified by the
manufacturer. If the product is used for
inflation, always follow the instructions
for maximum inflation pressure from the
manufacturer of the inflatable product.
• Check that the power switch is switched
OFF and that the pressure gauge on the
regulator shows 0 before changing tools
and before releasing the air hose from
the quick-coupling on the product.
Failure to follow these instructions can
lead to the risk of serious personal
injury.
HOW TO USE
Running-in
Before using for the first time, fit a fully
charged battery with a capacity of 4.0 Ah
and run the product without pressure in the
air tank, with the drain valve fully open, for
30 minutes or until the battery is completely
discharged (whichever happens first).
WARNING!
• Explosion risk! Do not adjust the
pressure regulator setting to a higher
output pressure than specified for the
maximum pressure for the tool and/or
the product to be inflated. Never set a
higher pressure than 8 bar. Failure to
follow these instructions can lead to the
risk of serious personal injury.
• Compressed air tools can be intended for
higher air flows than this product can
produce. Follow the instructions for the
actual tool, otherwise there is a risk of
personal injury and/or material
damage.
1. Check that the power switch is switched
off and that the battery is disconnected.
2. Connect the air hose (sold separately)
according to the instructions.
3. Connect the 1/4" quick-coupling to the
tool or accessory to be used.
4. Fit the battery.
5. Set the power switch in the ON position.
EN
33