LENCO PDR-040 Bedienungsanleitung Seite 12

CAUTION!
Risk of injury!
Opening the device can cause injuries.
Fault Possible cause/action
No function - If the device has been disrupted by a
thunderstorm, a static charge or another external
factor, follow this procedure to resolve the
problem: Power off this device and power on it
again 10 seconds later.
- Disconnect the supplied adapter and then plug it
in again.
No sound - The volume may be set too low or in mute mode.
- In Bluetooth mode: Set the volume of the
external device to the maximum and then control
the volume by using "Rotary button (07)".
- If necessary, select another location to improve
No/bad radio
the radio signal.
reception
- Adjust the telescopic antenna to optimize the
radio reception.
No Bluetooth® - Take care to ensure that all settings have been
connection made correctly on all devices. The Bluetooth®
function may be deactivated on the external
device. (re) activate it, if necessary.
- Check whether the device to be connected is
switched on and is in search mode.
12. Specification
Device: Portable Bluetooth DAB Radio
Unit Dimension 155 (L) *90. 5mm (W) *32mm (H)
Unit Weight 285g
Display Type
Size
Bluetooth Specification
Supported Profile
Connection
Distance
Power
DAB Tuning Range
Preset Memory
FM Tuning Range
Power supply adaptor (For EU only)
Manufacturer: Shenzhen Tianyin Electronics Co. , Ltd.
Model number: TPA-67B050100VU01
Input voltage : 100-240V
Input AC frequency : 50/60Hz
Output voltage : 5V
Output current : 1.0A
Output Power : 5W
Average active efficiency : ≥73.63%
No load Power consumption : 0.1W
Use only the power supply listed in the user instructions
Lenco offers service and warranty in accordance to European law, which
means that in case of repairs (both during and after the warranty period) you
should contact your local dealer.
Important note: It is not possible to send products that need repairs to Lenco
directly.
Important note: If this unit is opened or accessed by a non-official service
center in any way, the warranty expires.
This device is not suitable for professional use. In case of professional use, all
LED Display
warranty obligations of the manufacturer will be voided.
48mm x 13mm
V5.0
A2DP, AVRCP, HSP
In 10 meters (open
Updates to Firmware and/or hardware components are made regularly.
area)
Therefore some of the instruction, specifications and pictures in this
Class II
documentation may differ slightly from your particular situation. All items
Band III;
described in this guide for illustration purposes only and may not apply to
174.928MHz –
particular situation. No legal right or entitlements may be obtained from the
239.2MHz
description made in this manual.
30 stations
87.5 - 108MHz
12
Stereo/Mono
Preset Memory
Antenna
Audio Output Power Output Power
Freq. Responses
Power Source Input Micro USB Port
PC's USB port Power or DC 5V, 1A
Built-in-Battery Lithium 3.7V 2000mAh
Operating Temperature 0-40°C
Guarantee
Disclaimer
Selectable
30 stations
telescopic type
1X3W RMS
80Hz to 16, 000Hz