Remote Control - Technics SL-G700M2 Bedienungsanleitung

Remote control

■
Buttons that work for this unit
01 [NWP ]/[CD ]: Standby/on button
• Press to switch the unit from on to standby
mode or vice versa. In standby mode, the
unit is still consuming a small amount of
power.
The input source also switches for each
(switches to the last selected input source
when [NWP ]).
02 [NWP]/[CD]: Select the device to be
operated
• The current playing layer is displayed by
pressing [CD] while the playback stops for
Hybrid Super Audio CD (SACD). Press again
to switch the layer.
• Press and hold [CD] to switch to "Pure Disc
Playback" mode. ( 18)
03 [>INPUT<]: Switch the input source
04 [ ]: Open or close the disc tray
05 [INFO]: View content information
06 [ ], [ ], [ ], [ ]/[OK]: Selection/OK
07 [RETURN]: Return to the previous display
08 [MQA]: Switches MQA decoding function
to "On"/"Off"
• "MQA Decoding : On" is displayed when the
function is "On".
• Press repeatedly to switch the function.
09 [DIMMER]: Adjust the brightness of the
power indicator, display, etc.
• Press repeatedly to switch the brightness.
10 [MENU]: Enter menu
11 [SETUP]: Enter setup menu
12 Playback control buttons ( 17)
13 Numeric buttons, etc.
• To enter 2 digits or more
Example:
16: [ 10] > [1] > [6]
124: [ 10] > [ 10] > [1] > [2] > [4]
• [CLEAR]: Clear the entered value.
* : Press [NWP]/[CD] first to operate this unit.
(The remote control works only for the devices
supporting system control function when
pressing [AMP].)
■
Buttons that work for the connected
Technics devices
The remote control of this unit also works for
Technics devices (Stereo Integrated Amplifier,
etc.). For information on the operations of the
devices, please also refer to their operating
instructions.
[ ] Standby/on button
01
Select the device to be operated
02
Select the input source
03
Measure the output signal when speakers
04
are connected, and correct its output
Adjust the volume
05
Mute the sound
06
*
*
*
*
*
(11)
11