Troubleshooting Guide - Amewi AMXFlight AFX-PD100 Bedienungsanleitung

Problem
Helicopter and remote control are switched
on, LED at the tail is flashing, no function.
Nothing happens when the helicopter is
switched on.
The engine does not turn when the throttle is
opened, the LED on the receiver flashes.
The rotor turns but the helicopter does not
take off.
The helicopter vibrates very strongly.
The helicopter turns to the left after takeoff.
The helicopter drifts in one direction.
The helicopter does not fly in all directions.
BEDIENUNGSANLEITUNG / INSTRUCTION MANUAL AMXFLIGHT AFX-PD100
TROUBLE SHOOTING GUIDE
Possible Cause
Helicopter and remote control are not
connected.
Flight battery is empty. Check the voltage of
the battery.
Batteries on the remote control are empty.
Remote control is off.
The battery is empty.
The battery is not inserted correctly.
The battery is empty.
The rotor blades are deformed.
The shaft is bent.
The tail rotor is bent.
The shaft of the tail motor is bent.
The screws on the rotor blade mounts are too
tight.
The tail motor has too little power.
The tail rotor is defective.
The tail motor is defective.
The servos must be trimmed.
Servo defective
Solution
Reconnect the helicopter and the remote
control.
Charge the battery
Replace the transmitter batteries.
Switch on the remote control.
Charge the battery.
Insert the battery correctly.
Charge the battery
Replace the rotor blades.
Replace the shaft.
Replace the tail rotor.
Replace the tail motor.
Loosen the screws on the main rotors.
Check the connection of the tail motor and
the tail rotor. If they are defective, replace
them.
Trim on the remote control as described in the
instructions.
Replace the defective servo.
32