Parts Replacement - Amewi AMXFlight AFX-PD100 Bedienungsanleitung

ROTOR BLADES
Remove the screw on the rotor blade holder using a Hex wrench.
When mounting, make sure that you do not overtighten the screw. The
rotor blades must be able to swing freely.
TAIL
First dismantle the housing and then remove the rear motor connector.
Pull the rear out to the rear Pay attention to the direction when installing.
BEDIENUNGSANLEITUNG / INSTRUCTION MANUAL AMXFLIGHT AFX-PD100

PARTS REPLACEMENT

When replacing the servos, pay attention to the direction of the connecting
rods. When replacing other control parts, pay attention to the installation
sequence and position.
When removing and replacing the tail rotor, please note the
direction. Place the new rotor on the motor shaft and press it gently
onto it. Make sure that it can turn easily.
MAIN GEAR
When fastening the screw, make sure that
the tail is vertical.
31