DeWalt D25911 Bersetzung Der Originalanweisungen Seite 26

EnGLIsH
4. Fit and adjust the bail/loop style auxiliary handle
make sure it is firmly tightened.
5. Hold the tool with main handle and switch on. The tool now
runs in continuous operation.
IMPORTanT: aLWaYs use two hands when operating the
tool. Refer to Proper Hand Position for the proper use of
the tool for both horizontal and vertical applications.
6. Always switch off the tool when work is finished and
before unplugging.
Wireless Tool Control™ (Fig. A)

CAUTION: Read all safety warnings, instructions and
specifications of the appliance which is to be paired with
the tool.
Your tool is equipped with a Wireless Tool Control™ transmitter
which allows your tool to be wirelessly paired with another
Wireless Tool Control™ device, such as a dust extractor.
To pair your tool using Wireless Tool Control™, push the on/off
switch 1 on the tool to the on position and press the Wireless
Tool Control™ pairing button on the separate device. An LED on
the separate device will let you know when your tool has been
successfully paired.
MAINTENANCE
Your power tool has been designed to operate over a long
period of time with a minimum of maintenance. Continuous
satisfactory operation depends upon proper tool care and
regular cleaning.

WARNING: To reduce the risk of serious personal
injury, turn tool off and disconnect tool from power
source before making any adjustments or removing/
installing attachments or accessories. An accidental
start-up can cause injury.
Lubrication
Your power tool requires no additional lubrication.
Cleaning

WARNING: Electrical shock and mechanical hazard.
Disconnect the electrical appliance from the power source
before cleaning.

WARNING: To ensure safe and efficient operation,
always keep the electrical appliance and the ventilation
slots clean.

WARNING: Never use solvents or other harsh chemicals
for cleaning the non-metallic parts of the tool. These
chemicals may weaken the materials used in these parts.
Use a cloth dampened only with water and mild soap.
Never let any liquid get inside the tool; never immerse any
part of the tool into a liquid.
Ventilation slots can be cleaned using a dry, soft non‑metallic
brush and/or a suitable vacuum cleaner. Do not use water or
any cleaning solutions. Wear approved eye protection and an
approved dust mask.
24
Transport
5 and

CAUTION: Accidental starting during transport!
• Always transport your tool with removed battery or
disconnected power supply cord.
• Check the tool for damage before use after transport.
Storage
• Before storage, remove the battery from the tool or disconnect
the power supply cable from the mains.
• Clean the tool before storage. Refer to cleaning.
• The storage place must be suitable for the weight of the tool.
• Store the tool in a cool and dry place.
• Store the tool in a place where they cannot be accessed by
children or unauthorized persons.
• Check the tool for damage before use after long periods
of storage.
Optional Accessories

WARNING: Since accessories, other than those offered
by D
of such accessories with this tool could be hazardous.
To reduce the risk of injury, only D
accessories should be used with this product.
Consult your dealer for further information on the
appropriate accessories.
Protecting the Environment
Separate collection. Products marked with this symbol
must not be disposed of with normal household waste.
w
Products contain materials that can be recovered or
recycled, reducing the demand for raw materials. Please
recycle electrical products according to local provisions. Further
information is available at www.2helpU.com.
SDS plus® and SDS max® are registered trademarks of
Robert Bosch GmbH.
WALT, have not been tested with this product, use
e
WALT-recommended
e