Werbung
Verfügbare Sprachen
Verfügbare Sprachen
12 Time & Date is shown.
-
Press the OK button.
-
Select the desired field by
turning the select button.
-
Press the OK button. The
relevant fields will start
flashing.
-
Select the correct value by
turning the select button.
-
Press the OK button. After all
fields are filled in correctly,
press OK.
The message in the screen to the
left appears.
The settings have been saved.
-
Select the desired zone
(usually zone 1) value by
turning the select button.
-
Press the OK button.
13 The device will go into an
'error' mode.
-
Press the OK button.
14 Parameter 2.1.1 appears:
select the correct boiler type
based on the code on the
type plate and sticker on this
control unit.
Boiler type:
0 = Not defined
1 = 28C
2 = 36C
3 = 28EC
4 = 36EC
5 = 32S
Press the OK button again.
-
If ERROR 142 is displayed after
installing the control unit, first
check that the wiring harness is
connected to the pump. If the
error persists, the control unit is
installed in a device pre-2023
and pump communication should
be turned OFF. Then follow the
next procedure:
NOTE: The Control unit has a 'sleep
mode' if no key is operated within a
certain time.
Activation occurs by any key
operation.
Werbung
