One-Key U-Turn Instruction; X-Pilot System Calibration; Propeller Saver Instruction - Modster P-40 WARHAWK Betriebsanleitung

Manual

One-key U-turn Instruction

The airplane comes with one-key U-turn function, which enable the plane to U-turn by the opposite
direction that the airplane is currently flying. Follow below steps to activate the function.
1. Place your plane heading to the take-off direction.
2. Do NOT unlock the throttle, press the activation button and hold for several seconds until you hear a
"beep" sound, the rudder surface will respond, meaning the one-key U-turn function is now activated.
NOTICE: Every time when you power on the plane, it requires to activate the one-key U-turn function.
To use this function during flight, press the one-key U-turn switch button,the plane will turn around
automatically, back to the opposite direction where it takes off.
To quit, just press again the switch button, or control
any servo stick(rudder/elevator), the plane will back to
your control immediately.No matter you flies the plane
under manual control or X-PILOT assist mode, when
you turn on the one-key U-turn function, the plane will
enter X-PILOT assist mode automatically to help
stably flying back. When you quit this function, the
airplane will back to the what the control mode it was.
CAUTION: This function is bound to the receiver,
instead of to the transmitter, which means the plane will U-turn ONLY to the opposite direction that the
plane is flying. It also means when the plane U-turns and passes the position where you activated the
function, the one-key U-turn function will NOT U-turn the plane back to the older position.

X-PILOT System Calibration

1. Turn the throttle stick to min position.
2. Power on the transmittaer and the receiver.
3. Do NOT unlock the throttle.
4. Keep the sticks as above picture for several seconds.
5. When you hear a "beep" sound, it means the X-PILOT system is
calibrated based on the horizontal level you are keeping it.

Propeller Saver Instruction

Base
Upper Part
10
One-key U-turn Activation
One-key U-turn Switch
The propeller saver keeps the propeller from damage,
and prevent the electronic components from over
current. When the airplane hits any obstacle, the
propeller will loose from the base. To install the
propeller back to the base, insert the upper part
centerly through the motor shaft, and hearing a "click"
sound to ensure it is secured.
MDX P-40 Warhawk
www.modster.at