Adjusting Input Sensitivity - AUDIOropa A-5211-0 Bedienungsanleitung

Please note:
There should only be one active transmitter within
a group! Additional activated transmitters with
the same group number will cause interference in
the sound quality. Should a simultaneous trans-
mission of several transmitters be desired, please
consider using TRX-1 transceivers instead.

2.5 Adjusting input sensitivity

The sensitivity of both the inputs »MIC« und
»AUX« can be set from 00 to 05. To set the sensi-
tivity, press the MODE-button. The »VOL« symbol


is indicated on the display. Use the » « and » «
buttons to set the input level as desired.
2.6 Power supply / recharge
The device is equipped with a rechargeable lit-
hium-ion battery of 3,7 V / 1100 mAh. The red
charging status LED is lit during recharge. The
LED switches off when the battery is fully loaded.
To charge the battery, plug the USB charging ca-
ble into the USB jack of the TX-1 and connect it to
a regular USB port (computer, laptop, USB power
supply). The charging cases MCB-10 and CB-20
are equipped with USB charging cables.
The charging cases DC-20 or DC-40 can be
used for charging larger amounts of RX-1 and
TX-1. Simply place the devices in the according
charging slots. If charging of a larger quantity of
batteries is required, it is possible to take the bat-
tery out of the compartment in order to charge it in
the charging bag RCB-20 (featuring 20 charging
bays).
English 14