Makita DHP489 Betriebsanleitung Seite 10

ASSEMBLY
CAUTION:
Always be sure that the tool is
before carrying out any work on the tool.
Installing or removing driver bit/drill bit
Optional accessory
Fig.9: 1. Sleeve 2. Close 3. Open
Turn the sleeve counterclockwise to open the chuck
as it will go. Turn the sleeve clockwise to close the
chuck. To remove the driver bit/drill bit, turn the sleeve
counterclockwise.
Installing side grip (auxiliary handle)
Optional accessory
Fig.10: 1. Side grip 2. Protrusion 3. Groove 4. Arm
When operating in the heavier load, using the side grip
enables to hold the tool more stably.
in the grooves on the tool barrel. Turn the grip clockwise
to secure it.
Depending the operations, you can install the side grip
either right or left side of the tool.
Adjustable depth rod
Optional accessory
Fig.11: 1. Depth rod 2. Clamp screw
depth. Loosen the clamp screw, set the depth rod to
desired position, then tighten the clamp screw.
Installing hook
WARNING:
Use the hanging/mounting parts
for their intended purposes only, e.g., hanging the
tool on a tool belt between jobs or work intervals.
WARNING:
Be careful not to overload the
hook as too much force or irregular overburden
may cause damages to the tool resulting in per-
sonal injury.
CAUTION:
When installing the hook, always
CAUTION:
Make sure to hang the tool
securely before releasing your hold.
Fig.12: 1. Groove 2. Hook 3. Screw
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool. To install
the hook, insert it into a groove in the tool housing on
either side and then secure it with a screw. To remove,
loosen the screw and then take it out.
Using hole
WARNING:
unintended purpose, for instance, tethering the
tool at high location. Bearing stress in a heavily
loaded hole may cause damages to the hole, result-
Fig.13: 1. Hanging hole
Use the hanging hole at the bottom rear of the tool to
hang the tool on a wall using a hanging cord or similar
strings.
Installing driver bit holder
Optional accessory
Fig.14: 1. Driver bit holder 2. Driver bit
Fit the driver bit holder into the protrusion at the tool foot
on either right or left side and secure it with a screw.
When not using the driver bit, keep it in the driver bit
holders. Driver bits 45 mm-long can be kept there.
OPERATION
CAUTION:
extremely, reduce the load or stop the tool to
avoid the tool damage.
other hand on the bottom of the battery cartridge to
control the twisting action.
Fig.15
NOTICE:
heating and damage to the tool.
Fig.16: 1. Vent
Screwdriving operation
CAUTION:
proper torque level for your work.
CAUTION:
inserted straight in the screw head, or the screw
and/or driver bit may be damaged.
body points to the proper fastening torque level (1 - 21).
If not, the hook
Place the point of the driver bit in the screw head and
apply pressure to the tool. Start the tool slowly and then
increase the speed gradually. Release the switch trigger
as soon as the clutch cuts in.
NOTE: When driving wood screw, pre-drill a pilot hole
2/3 the diameter of the screw. It makes driving easier
and prevents splitting of the workpiece.
10 ENGLISH
Never use the hanging hole for
When the speed comes down
Do not cover vents, or it may cause over-
Adjust the adjusting ring to the
Make sure that the driver bit is