Lionelo Thermup Go Bedienungsanleitung Seite 5

4. Do not immerse the product or power cable in water or other liquids.
Before use, make sure the product is dry.
6. Use the source of power 5V ⎓ 2A only.
5. Do not use the USB cable for other purposes than designed.
7. Do not connect the product to the source of power if there is no
bottle with liquid. The bottle must contain at least 60 ml of liquid.
must not be disposed of together with domestic waste because it may
pose a threat to the environment and human health. The worn-out product
must be handed over to the electrics and electronics recycling center.
Parts list (fig. A)
1. Velcros
2. Handle
Operating manual
1. Pour boiled water to the bottle, then fasten the Velcro on the sleeve
tightly.
2. Connect USB cable to the sleeve and power source (charger/ power
bank/ USB port in the vehicle) (fig. B).
The product complies with requirements of EU
directives. Pursuant to the Directive 2012/19/EU, this
product is subject to selective collection. The product
‑ 5 ‑
3. Temperature sensor unit
4. USB-C cable
EN