Intended Use; Assembly And Adjustment - Worx Professional 700.1 Bedienungsanleitung

Intended use

Note: Before using the tool, read the instruction book
carefully.
The machine is intended for cutting, roughing and brushing metal
and stone materials without using water. For cutting stone, a cutting
guide is required. The machine is not intended for working with
diamond cutting heads.
For machines with electronic control: With approved sanding tools,
the machine can be used for sanding and polishing.

Assembly and adjustment

MOUNTING THE PROTECTIVE DEVICES
1
AUXILIARY HANDLE
For all work with the machine, the auxiliary handle (3) must be
mounted. Screw the auxiliary handle (3) on the right or left of the
machine head depending on the working method. (See A)
Do not make any alterations to the auxiliary handle.
Do not continue to use an auxiliary handle if it is damaged.
MOUNTING THE GRINDING TOOLS
Before any work on the machine itself, pull the mains plug.
All manuals and user guides at all-guides.com
1
2
3
10
Grinding and cutting discs become very hot while working; do
not touch until they have cooled.
SPINDLE LOCK BUTTON
Clean the grinder spindle and all parts to be mounted. For clamping
and loosening the grinding tools, lock the grinder spindle (7) with the
spindle lock button (4).
Actuate the spindle lock button (4) only when the grinder
spindle is at a standstill!
GRINDING/CUTTING DISC
Pay attention to the dimensions of the grinding disc. The
mounting hole diameter must fit the inner flange (6) without
play. Do not use reducers or adapters.
When using a diamond cutting disc, take care that the direction-
of-rotation arrow on the diamond cutting disc and the direction of
rotation of the machine (direction-of-rotation arrow on the machine
head) agree.
For mounting, see the Component list illustration page.
Screw on the outer flange (5) and tighten with the two-pin spanner
(9). (See B)
ADJUSTABLE OUTER FLANGE CLAMPING
The outer flange (5) should be adjusted to suit different disc
thickness. For thinner cutting or diamond discs the raised part of the
outer flange is fitted facing away from the disc (See C.2). For thicker
grinding discs the raised part of the outer flange is fitted facing
towards the disc to provide improved support for the disc hole (See